Kitchen appliance 5 Sabaf Burner Tempered glass Stainless Steel Water Tray built-in gas hob RDX-GHS026
Kitchen appliance 5 Sabaf Burner Tempered glass Stainless Steel Water Tray built-in gas hob RDX-GHS026
Get the best quality kitchen appliance - Sabaf 5 Burner Gas Hob RDX-GHS026. Built with tempered glass and stainless steel, it includes a water tray. Directly from our factory.
Brown box 5 layers with tape seal. with simple foam+pearl wool. Gift box optional !
14
Gas Type:
LPG or NG
15
Product Size:
870*510
16
Carton Size:
910*550*130
17
Cutout Size:
18
Loading QTY:
20GP/40HQ：400/1100pcs
Process Flow of Tempered Glass Processing Process flow of tempered glass processing: cutting -- edging -- cleaning -- tempering cutting 1. Start the glass cutting machine (including the computer and printer) 2. Input the original sheet specification, cutting sheet quantity, specification and size into the computer, and the computer will automatically jigsaw to calculate the original sheet quantity and utilization rate. 3. Print the result of the jigsaw puzzle and transfer it to the glass cutting machine. 4. Load the original piece of glass on the cutting table of the machine and position it as required. 5. Select and run the cutting program to cut the glass. 6. Separate the cutting pieces and transport them to the designated rack. Edging 1. Adjust the machine parameters, that is, the grinding amount, the pressing width, the transmission speed and the air pressure value of each polishing wheel when polishing is required. 2. Trial grinding: a piece of glass with the same type and thickness as the glass to be ground shall be used for trial grinding to check whether the grinding amount, front and rear chamfers and edge grinding quality meet the requirements. If they do not meet the requirements, readjust them until they are satisfactory, and confirm the parameters. 3. Load glass edging. 4. Check the edging quality and adjust the machine parameters appropriately. 5. The polished glass shall be moved to the designated glass shelf and labeled. clean 1. Check the glass washer before use to see if the water is sufficient. 2. Start the washing machine (including the water treatment system) and put the machine in automatic operation. 3. Load glass for cleaning and check the cleaning effect. If it is unqualified, adjust the water temperature, cleaning speed and transmission speed until it is qualified. 4. Load the glass according to the specified order and specifications, and automatically clean it. 5. When the cleaned glass is stacked, the blocks shall be separated with paper, and the specifications shall be separated and marked to avoid damage and confusion. Tempering 1. Check whether the cleaned glass meets the requirements. Glass with sand inclusion, scratch and other defects cannot be tempered. 2. Adjust the parameters of the tempering furnace according to the drawing requirements of the deep processing glass. 3. First take 2 pieces of similar glass with the same thickness for tempering, and check whether the tempering effect meets the requirements. 4. Loading glass is tempered. 5. The tempered glass shall be carefully inspected, and the qualified products shall be transported to the designated glass shelf.
